Introduction The purpose of this lab is to scrutiny Hookes law, the law of hold outable cut back that states that the amount of stretch of something is directly comparative to the quarter applied. The test will be conducted by placing weights on the end of respective(a) springs and measuring their stretch. If the most weight is placed on the largest spring, because it will stretch the most. force/Materials Materials needed: - Ring fend for/ backup man tower - 3 springs of carious sizes - writing clip - Masking tape - Meter place - set(p) of slotted deal - Large rubber band - Graph Paper Procedure: 1. We first hung one of the springs, doesnt publication which one, from the paper clip, which was hung from our support stand. in that respect was a measuring stick on the support, so we did non use the meter stick. 2. We therefore measured where the end of the paperclip rested, and used that as our a priori zero. 3. We consequently attached several(predicate) pas seles to the end of the spring. later every time we added a mass, we measured where the paperclip was resting, and preserve the mass in kilograms and stretch in meters into our data table. 4. We thence repeated steps 1-3 for the other(a) springs and the rubber band. 5. after we stainless steps 1-4, we calculated the force of distributively mass by multiplying the mass in kilograms by 9.84 m/s, the earths gravitational pull, to point the force of each mass in Newton meters. 6.
We then graphed the force (y-axis) vs. stretch (x-axis). 7. After graphing the lines, we found the spring unceasing for each spring by f inding the slope of each springs graph. Dat! a and Calculations         Mass         forces         Stretch         Spring Constant Spring 1         .4 kg         3.92 N         .005 M         1.000         .5         4.9         .01         ... If you want to get a full essay, order it on our website:
OrderCustomPaper.comIf you want to get a full essay, visit our page:
write my paper
No comments:
Post a Comment